Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen gezeigt.
Beide Seiten, vorherige Überarbeitung Vorherige Überarbeitung Nächste Überarbeitung | Vorherige Überarbeitung Nächste Überarbeitung Beide Seiten, nächste Überarbeitung | ||
projekte:2021:eurotwo [2021/04/15 20:29] max |
projekte:2021:eurotwo [2021/04/16 22:54] max [Errata] |
||
---|---|---|---|
Zeile 20: | Zeile 20: | ||
Mounted the first boards on the backplane. I started again with the ALU, similar to the preproject. Some wires left. Also the zero-detection logic is not mounted yet. But so far everything seems to work perfectly! | Mounted the first boards on the backplane. I started again with the ALU, similar to the preproject. Some wires left. Also the zero-detection logic is not mounted yet. But so far everything seems to work perfectly! | ||
- | {{: | + | {{: |
=== 2021-01-30 === | === 2021-01-30 === | ||
Zeile 111: | Zeile 111: | ||
==== Errata ==== | ==== Errata ==== | ||
+ | === ALL === | ||
+ | - Clearing around M2 holes bigger! The problem is that after some mountings and unmountings the soldermask gets holes and the Cu gets through. You got a short circuit than. Not good! Workaround: [[https:// | ||
=== HalfAdder rev1 === | === HalfAdder rev1 === | ||
- Silkscreen: AxorB -> A&B | - Silkscreen: AxorB -> A&B | ||
Zeile 123: | Zeile 125: | ||
- Silkscreen: LOW_A and LOW_B switched | - Silkscreen: LOW_A and LOW_B switched | ||
- En_A und En_B and High! | - En_A und En_B and High! | ||
+ | |||