ESP8266-07 bzw. ESP8266-12
USB-UART-Chip mit RESET
USB-Buchse (Micro oder C; Evtl. auch PCB-Anschluss wie beim Digispark)
Spannungsregler 5 V (oder mehr) ⇒ 3,3 V
Eine Power-LED für 3,3 V
Resettaste
Min. 2 Befestigungslöcher
vspace.one-Logo (evtl. auch QR-Code oder so?)
Hardware-Codierung
Onboard Taste(n) oder Joystick
Onboard-RGB-LED(s) (Normal an IOs oder WS2812, evtl. 1 je Seite)
Onboard-Buzzer
Anschluss für 5 mm THT-LED mit Transistor (z. B. IR, extra hell, …)
IOs mit Pegelwandler ESP ⇔ Eingangsspannung
IOs mit Leistungstransistoren, OpenCollektor (u. A. zum Relais und PC-Lüfter schalten)
Herausführen von IOs + Betriebsspannung (evtl. passende Pinbelegung+Abstand zum Anschließen von Servomotoren)
I²C sowie SPI, vor sowie nach Pegelwandler (so, dass man JST oder ein Displaymodul bestücken kann, evtl. auch beides)
Sensorik (Beschleunigung, Licht, Temperatur/Feuchtigkeit, Magnetfeld, Luftdruck, …)