Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen gezeigt.
| Beide Seiten, vorherige Überarbeitung Vorherige Überarbeitung Nächste Überarbeitung | Vorherige Überarbeitung Letzte Überarbeitung Beide Seiten, nächste Überarbeitung | ||
|
projekte:2021:eurotwo [2021/04/15 20:29] max |
projekte:2021:eurotwo [2021/05/06 16:14] max |
||
|---|---|---|---|
| Zeile 16: | Zeile 16: | ||
| ==== Status ==== | ==== Status ==== | ||
| Follow [[https:// | Follow [[https:// | ||
| + | |||
| + | === 2021-05-06 === | ||
| + | Seems that the connection solution is not optimal. The Cu zone is to close to the mounting hole. So the cable scratches the solder mask and creates short circuits. My current solution is to use plastic washers to create some distance. But now the nuts on the bottom of the boards are required to directly touch the boards for a reliable connection. Microscope images of the follow. | ||
| === 2021-04-15 === | === 2021-04-15 === | ||
| Zeile 111: | Zeile 114: | ||
| ==== Errata ==== | ==== Errata ==== | ||
| + | === ALL === | ||
| + | - Clearing around M2 holes bigger! The problem is that after some mountings and unmountings the soldermask gets holes and the Cu gets through. You got a short circuit than. Not good! Workaround: [[https:// | ||
| === HalfAdder rev1 === | === HalfAdder rev1 === | ||
| - Silkscreen: AxorB -> A&B | - Silkscreen: AxorB -> A&B | ||
| Zeile 123: | Zeile 128: | ||
| - Silkscreen: LOW_A and LOW_B switched | - Silkscreen: LOW_A and LOW_B switched | ||
| - En_A und En_B and High! | - En_A und En_B and High! | ||
| + | |||