Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen gezeigt.
Beide Seiten, vorherige Überarbeitung Vorherige Überarbeitung Nächste Überarbeitung | Vorherige Überarbeitung Nächste Überarbeitung Beide Seiten, nächste Überarbeitung | ||
projekte:eurotwo [2020/06/18 13:32] max [Arrangement] |
projekte:eurotwo [2020/08/01 09:27] max [Status] |
||
---|---|---|---|
Zeile 50: | Zeile 50: | ||
==== Status ==== | ==== Status ==== | ||
+ | === 2020-08-01 === | ||
+ | My automated long term test is up and running. 1000 test-iterations per bit. Tuned the loading speed of the C (adding 100 Ohms), added diodes (1N4007) and tuned the holding voltage of the relais better by adding 100 Ohms. | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | === 2020-06-28 === | ||
+ | Fixed the "4-Bit Register rev2" board. The board is fully functional but has some drawbacks. You need to scratch away 8 traces on the board and solder 8 short wires on it. | ||
+ | |||
+ | The fixes for rev3 are: | ||
+ | * Cs were not aligned correctly to matching relais. Nobody will see this but still, it is not as intended! Fixed in rev3 | ||
+ | * There is a mistake at the store relays. That is why you need to scratch traces. Fixed in rev3 | ||
+ | * Rev2 is unable to select between rising and falling edge. This is fixed in rev3 by a jumper | ||
+ | * B.Mask is under the LED-Indicator on the back, that is why the light is not as bright as intended. Fixed in rev3. | ||
+ | * Numbering of the LEDs would be helpful. Fixed in rev3. | ||
+ | |||
+ | |||
+ | |||
+ | |||
=== 2020-06-18 === | === 2020-06-18 === | ||
The PCBs for the 4Bit Register and the Logo did arrive. I assembled them successfully. I'm now waiting for the new Relays HK19F for the final test of the registers. In the Logo-PCB there was a little mistake but I succeed fixing it by scraping away two traces. | The PCBs for the 4Bit Register and the Logo did arrive. I assembled them successfully. I'm now waiting for the new Relays HK19F for the final test of the registers. In the Logo-PCB there was a little mistake but I succeed fixing it by scraping away two traces. |