Dies ist eine alte Version des Dokuments!
EuroTwo CPU
Status
2020-10-28
I tried a different setup of the logo illumination by using two PCBs. I sanded the backside of the first PCB and assembled the LED in the other direction on the second one. This look much smoother and better!
2020-10-18
2020-08-10
I designed a testing board with a SN754410 H-Bridge driver for testing. I can test 4 outputs and 4 inputs per testing board easily with an Arduino now. The SN754410 is still in delivery and will get assembled later.
2020-08-01
My automated long term test is up and running. 1000 test-iterations per bit. Tuned the loading speed of the C (adding 100 Ohms), added diodes (1N4007) and tuned the holding voltage of the relais better by adding 100 Ohms.
2020-06-28
Fixed the „4-Bit Register rev2“ board. The board is fully functional but has some drawbacks. You need to scratch away 8 traces on the board and solder 8 short wires on it.
The fixes for rev3 are:
- Cs were not aligned correctly to matching relais. Nobody will see this but still, it is not as intended! Fixed in rev3
- There is a mistake at the store relays. That is why you need to scratch traces. Fixed in rev3
- Rev2 is unable to select between rising and falling edge. This is fixed in rev3 by a jumper
- B.Mask is under the LED-Indicator on the back, that is why the light is not as bright as intended. Fixed in rev3.
- Numbering of the LEDs would be helpful. Fixed in rev3.
2020-06-18
The PCBs for the 4Bit Register and the Logo did arrive. I assembled them successfully. I'm now waiting for the new Relays HK19F for the final test of the registers. In the Logo-PCB there was a little mistake but I succeed fixing it by scraping away two traces.
Downloads
- EuroTwo OnePiece v0.004.0 Schematic [PDF] (untested)
Arrangement
Sizes/Standards
Boards
- 2x FullAdder / 4x HalfAdder
- 4x Controlled Inverter from 4Bit Relay Adder
- 9 Bit AND
- 4 Bit Register
- MUX 1-4,1-16, DEC 1-4,1-16, 4 Bit MUX 1-4
- Clock
- RAM
- ROM
- Logo
Logo
This board is made of 120 LEDs just for this board. It is the projectlogo with through-pcb illumination.
Schematics
- left
BOM
Designator | Package | Quantity | Designation |
---|---|---|---|
D* | LED_1206_3216 | 120 | blue at 16mA, 5V |
R* | R_0603_1608 | 120 | 330R |
C1,C2 | CP_Elec_6.3×5.4 | 2 | 47uF |
C3,C4,C5 | C_0805_2012 | 3 | 100nF |